This module is available in two versions:

  • WIFI-2 which needs an external RF antenna plugged on the i-PEX MHF receptacle
  • WIFI-2-IA without the i-PEX MHF receptacle using the onboard PCB antenna

Both models are available with a 6 pin pitch 2mm solded on semi-holes to be plugged on a female connector or welded directly on the PCB.

Buy on-line

WIFI-2
EUR 7.00


WiFi USB module

OEM Small USB 2.0 IEEE 802.11 b/g/n Wi-Fi compliant module based on the RaLink RT5370N chip. It works at 3.3V and can be configured also in Access Point mode.

This model requires an external antenna model AN-WIFI-01 or AN-WIFI-02.

| Product description |

AN-WIFI-01
EUR 3.50


WiFi pcb external antenna

WiFi PCB antenna with 11 cm cable and UMC 2mm connector to be plugged on WIFI-2 module.

| Antenna datasheet |

AN-WIFI-02
EUR 7.00


WiFi external antenna with SMA cable
  • RF cable with panel mountable SMA connector and UMC 2mm connector to be plugged on a WIFI-2 module.
  • WiFi rubber antenna

| Antenna datasheet | Cable datasheet |

WIFI-2-IA
EUR 7.00


WiFi USB module (Internal Antenna)

OEM Small USB 2.0 IEEE 802.11 b/g/n Wi-Fi compliant module based on the RaLink RT5370N chip. It works at 3.3V and can be configured also in Access Point mode.

This model uses the internal PCB antenna. The operative range of this solution is limited to few meters (2-3 mt). If you need a greater distance evaluate the model with external antenna.

Don't use the WIFI-2-IA model with Arietta G25 board because it hangs the CPU. Use the WIFI-2 instead

| Product description |

STRIP-011
EUR 0.20


Male strip 7x1 pin pitch 2mm

Male strip 7x1 pin pitch 2mm

  • Male strip
  • 7x1 pin
  • Pitch 2mm
  • Used on WIFI-2 module

STRIP-012
EUR 0.30


Female strip 7x1 pin pitch 2mm

Female 7x1 pin pitch 2mm

  • Female strip
  • 7x1 pin
  • Pitch 2mm
  • Compatible with WIFI-2 module