LA–126 MULTICHANNEL MONITOR CONTROLLER

The LA 126 is especially designed as a multichannel level controller.
LA-126 can control up to 16 channels

3 FUNCTIONS:

• STEREO 1. 2 channels control ( left/right. input/output 13/14 )
• 7.1.4 12 channels control ( Dolby Atmos. input/output 1/12 )
• STEREO 2. 2 channels control ( left/right. input/output 15/16 )

Illuminated 3 position rotative switch
Level control by VCA. One knob only controls all the 16 outputs.

LA-126 can be used as a remote control if it is placed outside of the desk. DB-25 pole connectors on back panel

LEVEL CONTROL

• The correct use of the la-126 unit requires a proper level regulation procedure
• Send to the la-126 unit the signal with the right work level
• Set the level control of the la-126 unit in position “two o’clock”
• Increase the external amplifier level control in order to have the correct listening level
• In some cases it is necessary to insert an external attenuator at the amplifiers’s input

LA-126 REMOTE




Insert the jack only when the unit is turned off



The insertion of the rear jack deactivates the control on the front panel

The insertion of the front jack deactivates both the control on the front panel and the remote insert on the rear jack

Technical specifications

Channels	total 16 1-12 reserved for Dolby Atmos; 13-14 Stereo1; 15-16 Stereo2
Input Input level Input impedance	Electronically balanced +4dBu, Max +28dBu > 10 kΩ
Output Output Level Output impedance	Electronically Balanced -25dBu > Max 0dBu 100Ω ( minimum external load 600Ω )
Bandwidth	10 - 100.000 Hz @ -1dB perfect square wave up to 20kHz
Distortion + Noise	<0.005% ( typical 0.001 %)
Connectors Input-Output Remote Control	DB 25 on Rear Panel Jack TRS on Front and Rear Panels
Functions Design Three In/Out Selection Switching system	100% high-end analog design Stereo1; Dolby Atmos; Stereo2 Sealed Relays. Not used outputs are grounded to avoid noise and cross-talking
Power Supply Operating Voltage Power Consumption Rear Panel AC mains	Switching Double filtered + Linear Regulators 110 - 230V 50-60 Hz 20 W IEC C13 16 A connector, AC mains cord with IEC Schuko
Construction Dimensions Weight	1Unit, 19" rack mount stainless steel W 483mm 19"/ H 44 mm /1.75 " D 250 mm /9.8" 4 kg



Depliant PDF



Manual