Daisy a fast prototyping cabling system
Daisy is a set of small and versatile modules for adding on-field interfaces at your Acme Boards:
A rich set of in-field interfaces like RS232, RS485, RS422, Relay, industrial I/O, MBUS, led, GPIO, display, GPS, MEMS,
A/D converters, GPRS modem etc. are already available and many more will be available in the next months.
Daisy modules compatible with Terra board G25 and FOX Board G20
|
GPS, gyro, compass, barometer, accelerometer, thermometer with I2C interface
|
|
Two relays and two filtered input add-on board
|
|
One relay add-on board
|
|
Stepper motor driver (2.5A)
|
|
RS232 serial port
|
|
RS485/RS422 optoisolated serial port
|
|
Four channels 48V optoisolated digital inputs
|
|
Four channels 48V optoisolated outputs
|
|
Four channels @ 10 bits 0-10 volt A/D inputs
|
|
Alphanumeric 16x2 LCD + 4 push buttons front panel with I2C interface
|
|
LED and & Breakout for lab purpose
|
|
Eight buttons add-on board for lab purpose
|
|
Eight leds for lab purpose
|
|
Proto board for lab purpose
|
|
Adapter for 4Dsystem touch screen displays
|
|
Amber AMB8425 MBus radio module
|
Daisy module for FOX Board G20
|
Adapter for FOX Board G20 or Netus G20 SoM
|
|
Audio board FOX Board G20
|
Buy
|
Acme Systems srl
Via Aldo Moro 53 - 00055 Ladispoli (RM) - Italy
P.IVA/C.F. 08114831004
Tel +39.06.99.12.187 - Fax +39.06.622.765.31
http://www.acmesystems.it -
Iscritta al Registro delle Imprese di Roma al n. 08114831004
|
Atmel© Certified Partner
|
Documentation Terms of Use
Acme Systems provides this documentation "as is" without warranty or guarantees of any kind.
The mantainer of this site (Sergio Tanzilli), has gone to a great deal
of effort into making this documentation as correct as possible.
Acme Systems doesn't provide any direct support for the Open Source preinstalled software but provides, through
these pages and forum posts, all the information required to obtain the sources, install, use and update the
Open Source softwares runnable on the FOX Board, NetusG20, AriaG25 and Terra platforms.
Please note that all the preinstalled softwares, used on the Acme Systems products, are Open Source and you will
have to check the license terms provided (usually the GPL) by each author before using it in any commercial or non-commercial
product, by yourself.
Before sending emails or calling the Acme staff here are our contacts
please note that WE ARE MAINLY HARDWARE DESIGNERS and NOT LINUX GURUS so could be better to post
your questions directly to the forum listed below to be sure that all the contributors of this site and
the large software developers community will read and reply to your questions.
This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 3.0 Unported License.