Select the board model to show the specific technical documentation
h10 foxd27 yarm roadrunner acqua aria arietta cm3-panel-7-basic cm3-panel-7-poe cm3-home foxg20 foxlx netus terraFOX Board D27 technical documentation
Downloads
Create the Linux boot images from scratch
- Compiling AT91bootstrap 4.0.4
- Compiling Linux Kernel 6.1.38 LTS
- Build a customized Linux Debian image with Debos
Peripherals how tos
- General purpose I/O (GPIO lines)
- Manage the GPIO lines from command line with gpiod
- Manage the GPIO lines in Python3 and C with libgpiod
- Manage the GPIO lines using Node-RED
- Manage the GPIO lines using the Microchip Peripheral I/O Python Package
- Manage the GPIO lines using the sysfs user interface (deprecated)
- Manage the special GPIO lines
- Check the current gpio setting: less /sys/kernel/debug/pinctrl/fc038000.pinctrl-atmel_pinctrl/pinconf-pins
How tos
- Blink
- Installing nodejs on FOX D27
- Install the H10 SDK on FOX Board D27 SBC
- OpenOCD on FOX Board D27
- DAFFY-4 - Four relays outputs and four clean contacts input DIN rail I2C board
Hardware references
- FOX D27 schematic
- ACME Sensor ports on FOX Board D27
- Pinout
- RoadRunner - Linux embedded system on module
- RoadRunner (Microchip SAMA5D27) technical documentation
- Microchip SAMA5D27 Datasheet
Declarations of conformity
Related products
- CPU Microchip SAMA5D27
- Cortex A5 @ 500 MHz
- Very low power consumption:
396mW in full speed mode
198mW at Linux prompt
17mW in standby mode
10mW in suspend to RAM mode - Armhf architecture
- DDR3L RAM 256 MB
- QuadSPI 0/16/64/128MB
- Size: 40x30 mm
- Plug-in module
- 200 pins 0.4 mm pitch
- TFT parallel interface
- Boot from internal Quad SPI or external uSD/eMMC
- Linux Kernel 5.15 LTS
- Debian, Buildroot and Yocto
- Open source drivers
